Sold in 7 kg buckets
CLASSIC – POINTING MORTAR
Masonry mortar with improved adhesion for making joints. It is perfect for pointing porous cement and gypsum STEGU cladding. It is also used for pointing: clinker
in masonry walls (non-reinforced and not transmitting loads), facade clinker tiles, concrete tiles imitating e.g. brick, stone or sandstone as well as gypsum tiles fixed
to any stable surface, and such difficult surfaces as chipboard, plastics or rustless metals. It is resistant to atmospheric conditions (freeze proof and waterproof).
It can be applied indoors in walls made of brick, concrete or gypsum-cardboard panels, on external facades of buildings and posts in general construction.
Prior to pointing, make sure that the previously applied joint of the clinker or tiles is dry (2-3 weeks after completing mounting). Next, remove all residues and flaking layers
as well as dust deposited from the joints.
Prepare the mortar in portions up to 2 kg at a time, in a clean bucket, with a low-speed mixer, adding the previously measured minimum quantity of water. If necessary,
water can be added to complete to the boundary volume until a homogenous and humid mixture is formed. The mortar consistency must not be too thin or stick to hands. Do not prepare more mortar than for 15 minutes of work at a time. (It is recommend
to use the application technology at a semi-dry consistency so that a ball made
of the mortar breaks apart after hitting it softly).
Press the mortar strongly and evenly with a jointing trowel (with an appropriate width) and then smooth it out by spr eading evenly. Vertical joints can be finished with a short jointing trowel (do not smooth the mortar several times as it can result in a glazing gloss). Once the mortar has set, remove the mortar residues with a brush. During work and for about 48 hours after completing works, the wall must be protected against strong sunlight, rain and wind. If tiles are incidentally stained, do not clean the façade with a wet sponge or cloth. Possible efflorescence is not a result of the product defect but a natural phenomenon vanishing after maximum two years.
Jointing trowels, flat or shaped steel plate tray, mixer, bucket, gloves.
(The tools must be clean prior to starting work !).
Adding different quantities of water at the same quantity of mortar may result in colour differences. If the mortar is too wet or the tools dirty, it may result in some additional efflorescence and permanent soiling of the façade. Do not use mortar that will fall
onto the substrate at pointing (it will have a negative impact on the joint appearance and durability).
Non-soiling masonry mortar contains cement and has an alkaline reaction after mixing with water. Protect the epidermis and eyes. In case of contact with eyes, rinse the eyes thoroughly with plenty of water and if the eyes become red, seek medical help.
Keep out of the reach of children. Do not inhale dust.
Store the pointing mortar in undamaged containers, in a dry place. Guarantee period: 12 months (white and ecru) or 6 months (grey and graphite) from the production date on the packaging.
Performance depends on the type of jointed elements, the joint width and depth, e.g.:
clinker with a 10 mm wide and 6 mm deep joint – ca. 2 m2/7 kg of mortar,
RODOS indoor gypsum tile – ca. 1.5 m2/7 kg of mortar.
With regard to the printing technology, the colours of joints presented on the packaging shall be treated as demonstrative.
POINTING MORTAR – TECHNICAL DATA
Mixing time: Mixing twice necessary (2 x 1 min.).
Second mixing after curing for ca. 3 min.
Mixing ratio: 0.7 – 0.9 l of water per 7 kg.
Ambient and substrate temperature at completing works: +5 to +20 degrees Celsius.
Time to use the prepared mixture: up to 20 minutes
Initial setting time: 24 hours
Complete setting time: 28 days
Efficiency: to 2,5 m2 per container.